OBD scanner for ABS? - Nissan Forums : Nissan Forum
 
» Auto Insurance
» Featured Product
Wheel & Tire Center


NissanClub.com is the premier Nissan Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 07-24-2009, 02:07 PM
Registered User
 
Join Date: May 2004
Posts: 20
Thanks: 0
Thanked 0 Times in 0 Posts
iTrader: 0 reviews
OBD scanner for ABS?

Hey guys,

I've got an '02 2.5S and the ABS started wigging out after I did some maintenance (axles, bearings, rear hubs, rotors and pads).

Under anything more than extrememly light pressure on the brake pedal I get a cycling of the ABS. Maybe 10 pulses, then back to normal for a few feet then antother series of pulses. I'm pretty sure that one of the wheel speed sensors is acting up and I would like to isolate which one.

So I was wondering, is there an over the counter code scanner out there that can pull the ABS codes on our cars?

The closest dealer to me is 3 hours away and the last time I had it there it turned into a huge engine replacement fiasco, so if I can avoid that route, I'd feel much better.

So is there a code scanner that can pull ABS codes?

Cheers
Brett
__________________
Brett
Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
  #2 (permalink)  
Old 07-25-2009, 10:17 AM
jimnolimit's Avatar
2010 2.5s Sedan
 
Join Date: Aug 2006
Location: brooklyn
Posts: 5,140
Thanks: 0
Thanked 1 Time in 1 Post
iTrader: 0 reviews
you probably disconnected/damaged the wire to the wheel speed sensor while doing the work .

autozone reads codes for free .

you could try pulling out the ABS fuse until you get the problem fixed .

good luck .
__________________
MY AUTO BLOG (COMPLETE WITH INSTALLS).

http://jimsautoeverything.blogspot.com/
Reply With Quote Quick reply to this message
  #3 (permalink)  
Old 07-25-2009, 01:04 PM
liljohnny's Avatar
Boomer
 
Join Date: May 2006
Location: Guelph,Ontario Canada
Posts: 1,688
Thanks: 0
Thanked 1 Time in 1 Post
iTrader: 0 reviews
I hate to tell you this but to the best of my knowledge, you'll have to g to the dealer to get those codes read. I had the same problem and tried several scanners but they couldn't isolate the problem other than saying it was an ABS problem. I'm not saying there isn't a scanner out there that can do it but it won't be any over the counter scanner....
__________________
Canucks Rool!
2002 3.5 Ruby
Blacked Out Chrome

Feedback Thread
http://www.nissanclub.com/forums/ven...ck-thread.html
Reply With Quote Quick reply to this message
  #4 (permalink)  
Old 07-25-2009, 06:31 PM
Registered User
 
Join Date: Aug 2008
Location: TX
Posts: 402
Thanks: 0
Thanked 0 Times in 0 Posts
iTrader: 0 reviews
johnnys right, dealer only bub. The only scanners I've seen that will even reccognize asian abs cost thousands of dollars.
Reply With Quote Quick reply to this message
  #5 (permalink)  
Old 07-31-2009, 04:45 PM
Registered User
 
Join Date: May 2004
Posts: 20
Thanks: 0
Thanked 0 Times in 0 Posts
iTrader: 0 reviews
After digging through the service manual, I found a way to get ABS codes without Consult-II.

1. Drive over 20mph for 1 minute.
2. Turn ignition off.
3. Ground pin-9 of the data link harness
4. Turn ignition on. (Do not hit the brake pedal or start the engine)
5. After 3 seconds the ABS will start flashing two-digit codes.

Looking at all the stuff you can do with the Consult-II though it's be nice to have but at $7000 not really an option.

Cheers
Brett
Reply With Quote Quick reply to this message
  #6 (permalink)  
Old 08-10-2009, 09:08 PM
Registered User
 
Join Date: May 2004
Posts: 20
Thanks: 0
Thanked 0 Times in 0 Posts
iTrader: 0 reviews
Even though it was the LF wheel that the ABS was cycling on, the Code given was 36 Rear Left Wheelspeed. I'll order up a new one post if that fixes it.
Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

  Nissan Forums : Nissan Forum > Nissanclub.com Nissan - Infiniti Enthusiast Forums > NISSAN ALTIMA FORUMS > 2002-2006 Nissan Altima Forums > 2002-2006 Nissan Altima Discussion (2.5 & 3.5)


Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Nissan Forums : Nissan Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Powered by vBadvanced CMPS v3.2.2

All times are GMT. The time now is 02:18 AM.


Powered by vBulletin®. Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.3.2
Garage Plus vBulletin Plugins by Drive Thru Online, Inc.