- Timing Chain Setup: 1st vs 2nd Gens
- clutch biting point
- hard to shift
- Heavy duty rubber hangars
- Codes P0440 and P1440
- Nology wires
- Ground Mod
- Easy Hp In Juste 5 Minute ! ?
- Removing cat
- Rough Idle/CEL Codes
- CAI Question.
- Idler pulley...tell me now!
- Stalling problem
- custom exhaust specs
- CAI Intake Problem.... HELP PLEASE
- Type R or H?
- Low end torque
- Mandrel Bent Piping Question...
- Engine Performance Newb...HELP!!!
- Did Tune up but still not done.........
- quick engine (mechanic) question
- I need help
- CEL codes...
- poly filled motor mounts
- Header problem fixed
- Dyo Problems
- dynod the car to day
- So after all that work
- question about peeling out..
- leaking coolant.
- HELP exhaust leak in front engine.
- remove front cat
- Fluid question...
- 94 engine swapped
- running a bit rich
- What kinda exhaust??
- Forced air
- Do parts from other nissans fit?
- High flow or no?
- port and polish? dremel kit?
- Anyone else this stupid???
- P0440 SEL and Hard-shifting tranny
- HP Gains??
- squeaking??????
- sr20det into a 1995 altima?
- faster faster
- Hubcap Rattle
- !!pulleys!!
- Check engine light HELP!!
- which engine?
- Ferrea Valves Question.....
- Intake Stall
- Help w/throttle linkage lever??
- now power at high rpm
- P0171 Bank 1, Fuel System Diagnostic - Too Lean
- Losing Spark?
- where to hook in oil pressure gauge on a first gen
- another ebay question
- second gen drive belt q??
- broke the maf sensor have with ebay air kit
- What plug wires are you using?
- Is a 2000 exhaust manifold and downpipe the same a a 97' 2.5L?
- won't start - got fuel and spark... what next?
- Street Legal Header
- Obx Type R Catback
- Fluid in sparkplug well
- eneven length header (STI Style)
- PR CAI and HS CAI question
- Help on OBx HEader install 01
- Exhaust Questions
- 99 to newer motor swap
- a few problems
- 00-01 swap
- Obd 1
- installation of O2 sensors, spark plugs, tuneup
- Wrong fourm but help with airbag sensor
- High Volume OIL pump install
- 94 engine replacement
- car just died for no reason?!?!
- weird noise with A/C
- Engine mod question
- 1st gen LSD auto tranny on Ebay cheap!
- What is the part under the Distributor Cap
- Chip for 97 up??
- What is this?
- Reverse
- hotshot header bolt
- SP2 for 2nd gens
- Alty Problems - Any Thoughts?
- how to change a 95 alty fuel filter?
- 00' Header install- O2 sensor issues
- fram air hog
- Would these mods make me fail a smog test?
- tell me how loud??????????????
- High Volume OIL pump
- Altima blowby, is this normal?
- Coolant Leak / Intake Gasket bad?
- Intake question
- Motor replacement
- plugged pre-cat?
- burning a little oil
- internal coil and msd??
- Do K&N air filters really do anything special?
- Major problem with the Alty.
- 95 Altima O2 sensor voltage?
- Retarded Header Style (pics)
- seized motor
- might be a stupid question might not be you decide
- 1st gen auto tranny problems HELP!
- engine light came on
- Just got my stuff done!!
- over heating problem?
- nissan performance
- Motor Swap
- engine management and electonics install
- race prep head?
- Thoughts on WRX Muffler?
- I need help!
- cam break in
- Place Racing Sucks!
- Intake questions...
- looking to swap
- sprak plug for 99 altima, gxe
- Alty420's Transmission EXPLODED Literally
- winshiled and hoodgone [looking 4 hood]
- Blower motor resistor block
- Anthing for 150 bucks?
- Oil Pressure Gauge Tubing
- Radiator where to buy a new one?
- Oil pump
- Greddy Sp2
- Sentra FilterCharger Shield, WeaponR ColdAirBox
- Piping Specs
- Just ordered first few parts
- RS*R
- Torque Info.
- jacobs ignition update
- Help w/Code 21 and 45 possibly
- Has this happened to anyone? Need Help
- Can I?
- I didnt make a CAI i made a WAI
- Nightmare at midnight
- EGR Questions
- Where to buy 3" ABS plastic pipe?
- Does anyone have the Apexi N1 muffler?
- Ready To Modify
- header problem
- place racing + n2o
- Wires
- Exhaust Gas Recirculation
- Battery cable...
- What make of muffler for 1st Gen Alti would make the best hp Gain?
- cat/resonator
- time for a new clutch
- What is best exhaust system for most hp Gain?
- Possible to clean 1st gen MAFs??
- thermostat, any ideas
- lil engine problem ( please help )
- transmission nock
- help swapping auto tranny
- Why so sluggish?
- Are there any real gains from just putting in a new muffler?
- 97 engine in 93 altima
- Camshaft Position Sensor
- Check it out AIT Temp
- CAI red hoses where do they go?
- Can some1 show me a pic of a CAI
- What should i use to cut the whole for the HOTSHOT CAI
- Got the distributor replaced but still problem
- loud hissing between 3000-3300 rpm + soundclip
- OBX downpipe with Hotshot header
- How snug of a fit was your hot shot
- Recommended lubricants and fluids...
- Got my hotshot CAI
- Lower Timing Cover Removal
- Flex pipe question.
- Fair price?
- tranny went Ka Boom
- ECU location?
- Magnaflow OBD II Cat
- how often should i change synth oil?
- need some opinions on exhaust
- AEM bypass + CAI
- My Engine Stall-out Nightmare
- Altenator problems
- Dry nitrous ...
- Emission advice
- y-pipe
- knock sensor resistor
- milage meter
- cryogenic intake
- Knock Sensor information
- Ac Questions
- oil in distibuter cap
- Cutting fender for CAI
- Are all Variable Capactiy muffler the same?
- Looking for a tranny
- matrix racing muffler
- Fitment of OBX catback with the ST rear sway bar?
- Gas smell from spark plugs.
- MAF sensor mods
- need -help- changing gear oil !
- Check Engine Dissapeared
- It was just a cracked flywheel. :)
- Fun With Cai's
- greddy on 2nd gen?
- Bad Oxygen sensor= Vibration???
- modified dist cap
- 2001 swap
- Question about Comptech Icebox and hydrolock
- Best prices on Magnaflow mufflers?
- dual valve springs and cam
- Octane equation
- ARE CF trunks avalible for 93-97 alty's??
- Part suggestion help... post all to help me
- Compression,timing.carbon
- What's a good aftermarket clutch for me??
- Custom Intake
- shoppin for a motor
- Another Suggestion About Reducing Heat In The Engine
- 3 long, 3 short... just installed HS Header
- Almost done with 1994 alty
- Should i get a CAI from Hotshot?
- its been a long time....
- 1st Gen Down Pipe Gasket fit HS?
- worried about header
- magnaflow ??????
- Help with ECU
- ECU reset
- Check Engine Light
- 300ZX Injectors
- after take off stock intake
- eliminating engine heat
- Overall Rating for Obx Headers
- Using Consult to check/adjust timing?
- EGR Bypass
- 2000 engine in a 1993
- For those who have done this install....
- Ignition Timing
- Anybody with this prob.
- Greddy E-manage is installed
- my exhaust
- what to do next?
- hotshot header
- Some of my picture of my parts and my car
- exhaust popping noise
- Greddy SP2 93-97 available soon!!
- need help
- Head Gasket=No Good, Mechanic chrg. $600
- hi flow cats