- cutting hole by wheel well for cold air intake nissan altima 1998
- New help finding a CAI for 1995 Nissan Altima
- rough idle and hard start after intake install
- catalytic converter
- Full Exhaust
- 1997 greddy exhaust for sale cheap
- Engine swap
- Car won't let me fill the tank..
- i need an honest opinion.
- i need an honest opinion.
- Relieve fuel pressure
- i need new cams.
- Fuel injector Problem 93 Altima
- Runs like @#$%
- Bomz Intake Installation Guide
- Intake cam?
- New Exhaust came in
- Anyone from Tulsa, OK?
- need help fuel seems to cut off. on a 1997 gxe
- Throttle Body Spacer Install
- intake differences from first gen to second gen
- rich idle ? fuel economy and vacuum leaks
- #1 Cylinder misfire when engine warm
- Throttle Body Spacer
- Engine Stalls!!
- Engine Stalls!!
- P0340 Cam Position Sensor - 96 Altima
- ka24de oil gallery open or closed
- Spark Plug removal and installation
- BOMZ intake Question
- Transmission Filter Replacement
- What headers and exhaust?
- bluebird
- short ram vs. cold air intake
- Timing Cover Removal (to
- looking for a oem style cf hood
- 2000 gxe wont start.
- Craigslist OBX Header and Cat Back
- Who Has Used SeaFoam in Their 2nd Gen
- 01 Altima with BOMZ Intake
- 01 Altima - Help Changing the Fuel Filter 02 Sensor Thermostat Distributor
- KA Dyno: 160whp/170wtq
- Suspension/turbo question
- Exhaust for sale greddy
- how in the hell
- remove cruise control
- Compression Test
- Gathering information
- MSD Blaster 2 Coil on stock distributor?
- parts for 99
- turbo
- Cruise Control Actuator
- Fuel Filter Replacement
- seafoam on 97 altima
- Car has hesitation...
- Should I get Headers?
- Cometic head gasket compression ratio help
- 93 Altima: idle RPMs not steady
- Random Wire
- japnese KA?
- exhaust
- Stalling And No Restart Until A Few Min
- Silicone Hose Reducer
- 5spd Swap Done!!!!
- Air Intake
- BOMZ Air Intake
- k&n vs sri
- Obx Exhaust Specs
- Spark Plug Socket Size
- Clutch Pin Location On My 1993 Nissan Altima?
- what do you guys think ?
- sr20det injector?
- Cheap Way To Increase MPG
- 240sx ka24de parts on 93-01 altima ka24de
- 5sp help
- Basic Bolt on Dyno Run
- Injen warm air intake - how to make it cold
- Performance Chip Question
- new painted j-spec valve cover
- 1993 Altima Project Car
- 00 altima gained power for some reason...
- 1st gen altima turbo?
- Seem to have hit a wall
- efispecialist altima tune.
- Tune-up parts question
- any1 have rust problems?
- Speedometer
- Safc Help Asap
- dual n1 exhaust
- timing chain
- 1999 obx header install rough idle/intake manifold part 3
- Dont want to spend the $425 HELP!!!
- OBD1 Conversion
- SAFC help
- ka24de: Stroker kit vs. Turbo
- Just got my Stillen header. Help needed.
- rough idle
- obx header install, rough idle, part 2
- egr valve
- New Owner, Need Help!
- SR20 swap?
- Wont run cold! Need Help.
- fuel psi gauge
- HELP Decideing OBX 4-1 or 4-2-1
- Need intake!!!
- Msd Ignition Test, post up pics
- building another ka ...
- 95 altima. alittle worst for wear. need ya
- engine misses and stutters
- obx header install, rough idle
- No Response From Gears
- suggestions on 2000 altima 2.4
- updates
- Intake Manfold Gasket 2001 Nissan Altima 2.4 L
- motor mount help
- 99 Altima-Se limited/ motor swap.
- Safc2
- Plugs and wires
- Rough running and possible overheat from WAI?!?!
- 2001 Nissan Altima Lean Code 0171
- Transmission
- Compression
- Exhaust Sound Clip Video
- Taz Rear Strut Bar Whose Interested?!
- Going Turbo on KA!!! but...
- Automatic Tranny issues when cold and snowing
- stalling when running above 2000 rpm
- Bomz intake install question??
- Serpentine Belt
- What is this noise?
- SR20 swap, trans questions
- motor mount inserts
- Where does this hose go?????
- Automatic TB question
- MMI Clearance
- Tuning?
- Howto: 248/248 cam swap
- degreeing brian crower stage 2 cams
- Next Mod?
- converted to obd1 now how to get codes ?
- Gas Consumption Issue
- nitrous
- Performance parts for a 97
- which of these cams?
- Idle
- Injector O-Ring Problem
- 94 and 95 altima ecu pinouts
- A/C fan Question
- Spark Plug Gapping
- G35 sedan muffler swap
- P0171 Fix?
- xcessive intake manifold
- Front Strut Removal,
- Help Help Help
- Magnaflow High Flow Cat?
- Throttle Body Spacer?
- Engine Sound
- 3inch exhaust
- Help with high idle/rpm
- cams timing help please ?
- C.a.i.
- 2001 ALTI idles too high in Park & Neutral
- Check it out
- Distributors
- Dynomax Muffler
- what battery instead of optima
- Cat. Converter
- Turbo 1995 Altima
- Starter?
- motor work coming soon opinions needed
- Cold Air
- safc help
- Want G35 flow
- running rich, terrible mpg, stalling, pulled codes....
- msd 2 step
- no spark in 98 altima
- Factory muffler VS Aftermarket
- OBX Exhaust
- 220whp N/A KA!
- car idles real bad help
- Did basic tune-up...HELP!!
- vq swap in 1 gen altima
- Just installed OBX 4-2-1
- Best for 97 alti CAI
- Help stillen header
- 98-01 altima turbo kit
- Help W/ Camshafts & Timing
- Cold at 1500rpm
- What Cat!!!?
- add hp
- New Exedy Clutch kit...
- Injen CAI problems issues...
- Random cut outs?
- 1995 Altime -Completely Stumped.....
- rebuild
- Altima gets some coverage...kinda
- Ah! Random Hose?
- OBX Exhaust Catback with OBX 4-2-1 Header
- Who Knew?!?!
- Header and cat converter
- Sr20ve Swap
- Where 2 get the best price on the BC stage 2 cams?
- Bomz Short Ram Intake
- Overheating at idle/Fine when driving
- Spun bearing and a thrown rod...
- fixing CEL problem with header
- header and exhaust question
- Tuned on Calumsult ECU: WOW
- Found this by searching, timing chain how to
- thermal intake spacer
- help! exhaust setup. please giv opinion
- price question
- would sentra 02-06 brakes lines fit a first gen
- Going to buy 93' Altima GXE
- Cat Converter Installation on a 1996 Altima GLE
- where to get obx header?
- crank pulley
- Qr25de Sentra Se-r Motor In 2nd Gen Altima
- ka24de spline count
- color code for harness
- Nos Kit Install
- 2001 GLE tune-up cont...
- Acura Vigor 2.5, 5 cylinder engine in 2nd gen altima
- Engine issue
- Cost of replacing exhaust system for 97 Altima?
- Hesitates at slower speeds
- 1997 KA24DE Engine in a 1998 Altima (DONE!)
- Preperation for turbo 1998 Altima se
- Is there anyway i can get my car to get more hp?
- Why does my new-to-me 1997 engine have two balance chains?
- Emissions help
- 99 altima injectors
- SR20DE Engine Swap & Power Steering and A/C Removal
- 2001 Altima GLE exhaust
- suspention
- Poor Gas Mileage in 99' Altima
- What type of coolant do I use?
- Does this mean my battery is done?
- Are you able to modify a 95+ Dizzy to work with a 93/94?
- 97 Altima Lean
- You have around $200
- Turbos
- what flywheel and clutch?
- IM running rich
- transmision adapter plate?
- cobra maf sensor on altima?
- My Exhaust Is Complete
- Intake
- buy bellhousing?
- is it true?