OBX Type H catback question

vipervic · #1 (**permalink**) 06-02-2009, 12:28 AM

Has anybody tried removing the stupid POS silencer piece that is in the muffler tip? i think its pointless and looks like some garbage. any suggestions?

rtkskater44 · #2 (**permalink**) 06-09-2009, 07:47 AM

u need an allen wrench.. and flathead..
un bolt all bolts inside exhaust
open up silencer vents via spinning the silencer with a flat head
once vents are stick screw driver in on of the vents and yank like a gorilla.. may need lube though.. mine was tough too get out

singhz4lyfe · #3 (**permalink**) 06-29-2009, 01:22 PM

how does the type-h sound.. i was going to get that..but i went custom on my bitch. jus wondering if it sounds good

vipervic · #4 (**permalink**) 07-05-2009, 06:59 PM

Quote:

Originally Posted by singhz4lyfe

how does the type-h sound.. i was going to get that..but i went custom on my bitch. jus wondering if it sounds good

it sounds grest. i went custom and heard a huge difference in it. the only problem i have is the stupid silencer in the muffler which i am about to remove

vipervic · #5 (**permalink**) 07-05-2009, 07:01 PM

[quote=rtkskater44;3774870]u need an allen wrench.. and flathead..
un bolt all bolts inside exhaust
open up silencer vents via spinning the silencer with a flat head
once vents are stick screw driver in on of the vents and yank like a gorilla.. may need lube though.. mine was tough too get out[/quote

i unbolted all the bolts and and tried to remove the silencer but its a pain in my ass. i still cant get it out. i soaked it down with rust penetrant and tried the screw driver and i got nothing. how did you remove it

singhz4lyfe · #6 (**permalink**) 07-06-2009, 06:25 AM

the silencer shud have been a screw on..if not take it to a exhsuat shop nd theyll take it off shudnt be too costly..crowbar-might get mess nd dent your exhaust pipe accidently..flat head sounds like a better idea. gudluck with tht