The Nissan Club banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Nissan Trucks & Off Road Forum
    Just changed out my engine. Same Year 2008, Titan SE Flex, Old engine was 280k misc probs. This one 150k much better shape. In replacing have had misc codes that we have fixed. Now have P0300 misfire and dont know where to start. This should be either Fire, Fuel , or Air right. Plugs are new...
  2. 2000-2003 Nissan Maxima Gen. 5 Discussion
    I have tried absolutely everything trying to figure this out, I have a '02 max and one day out of no were it started misfiring and I have figured out that cylinders 1, 3, 5 are not firing. All the stuff I have done so far: Compression test all cylinders 140psi Switched bank 2 coil packs with...
    ecu
  3. 2002-2006 Nissan Altima Discussion (2.5 & 3.5)
    So I have a 2005 nissan altima 2.5 that I forgot to tell people to not drive since it was out of oil short story it got a hole in it. Either way I was looking at the specifications of the engine and seen that 2007 2.5 engines are better in every way i have a car that has the engine and a...
  4. ECM / ECU Tuning
    My ECU wasn't communicating with my obd2 sensor. So I unplugged the ECU and it reset. The throttle body high circuit code popped up. Great! So I eliminated the ECU as the problem. I already changed the starter and the fusible link. New battery too and Yes I checked the voltage. It's 12 point...
  5. NISSAN ALTIMA FORUMS
    So I have a 2010 Nissan Altima, it has about 160k on it. Ac went out. Replaced all of the components to it, refrigerant, compressor, pressure switch, fuses, relays, and I can’t get it to work. But the actual AC compressor relay is apparently in the fuse block under the hood, or “engine control...
  6. 2007-2012 Nissan Altima Discussion (2.5 & 3.5)
    I have a 2010 Nissan Altima 2.5 S and I went to Best Buy to have a full sound system install the works sub amp ect. When I picked up car will barley go over 65 mph if in neutral and floor it won't go over 2.5 RPM plus VDC Off light and check engine light was on after I got it back from best buy...
  7. Engine Performance 2013-2018
    Wondering if I would need to get a separate ECU tune after I install an exhaust for my 2017 2.5SR
  8. 2007-2012 Nissan Altima Discussion (2.5 & 3.5)
    I don't remember being able to use the OBD/DLC connector to diagnose my car, I gave up years ago. This time I'm back and I'm adamant to fix this but I really need some help because I'm lost. I say lost because every test I did seems to indicate that everything is normal. COMPLAINT OBD devices...
  9. NISSAN ALTIMA FORUMS
    2009 Nissan Altima 2.5l QR25DE 110k. Ok so bottom CVT coolant/heater line was dry rotted and basically feel apart had huge leak went to replace the hose and thought why not Go ahead and replaced filter since hell all the CVT fluid was out dropped the pan replace filters has 2 put CVT fluid back...
  10. ECM / ECU Tuning
    Help!!! I have a Nissan 240sx that is ca18det swapped. I did not do the swap, and my problem is that it idles perfectly fine, but does not rev past about 2200-2300 rpms. It revs up to that point perfectly fine, and can stay there all day if you held it, but we cannot figure out why it is stuck...
  11. 2007-2012 Nissan Altima Discussion (2.5 & 3.5)
    Nissan Altima 2012 2.5 is essentially new, first big trip with her cross country trip. Limp mode (no engine light) I’m pretty sure it was too hot going through Nebraska. I stopped for a bit & it was fine but it happened again in CO. I don’t want to drive through Nevada and have it happen again...
1-11 of 11 Results
Top