The Nissan Club banner

1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
I already searched and couldn't find anything on this. I have been looknig through other posts and i saw that people have ran the wire through their hood release hole. I took off the side pannel on the drivers side. What things do i need to do to make it go through the hole. I see that tehre is that black plastic stuff under the carpet. Do anyone else know about any alternative ways to route the power wire other than the hood release. I looked around and that is the only place that i found on the posts that could be a way to run the wire(btw, i have a 8gauge power wire).
 

·
:) :) :) :) (: (: (: (:
Joined
·
172 Posts
^^^^this is not an alternate way of running the power wire... It is a thread explaining how to get the wire through the hood release grommet. It is not difficult at all. Just have a little patience.
 
1 - 4 of 4 Posts
Top