The Nissan Club banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone I am new to the forum and was wondering if someone can help. I have an 06 sentra spec v 2.5 L I had my check engine light on for a bad manifold assembly cat I had the entire exaust replaced from the manifold back flow master cat and stillen cat back as well as a cold air intake my check engine light is still on I have also been losing power on the top end and the bottom end is sluggish since before the replacements the power issue is still there it seems to be intermittent some times it runs pretty good it seems if I get on it on the lower end it will climb but not have that nice pull it used to if I feather the gas until where it's power band would be then get on it sometimes helps from about 4000 rpms to 5000 but the power band still seems non existent any idea I will try just about anything to bring my car back to life
 
1 - 1 of 1 Posts
Top