The Nissan Club banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,149 Posts
Discussion Starter #1
I know the top of the shaft is 10mm wide but anyone know what the thread width is?

Reason I ask is because there is a shift knob I want really bad but its only available in 10mm x 1.25mm thread width.

ANyone?
 

·
Registered
Joined
·
1,656 Posts
if i am not mistaking, you can use miata shift knobs on it.
 

·
Sarcastic Member
Joined
·
3,548 Posts
I would recommend hacking like 2 inches off the shifter before you add an aftermarket one.. The Altima's shifter looks like it could be used in a truck with its height haha.. Once you cut some length off, you can re-thread the shifter.
 

·
Registered
Joined
·
2,149 Posts
Discussion Starter #4
yeah the knob I want is a Miata Voodoo one.
 
1 - 4 of 4 Posts
Top