supernissans.net has a sticky on how to program key fobs.

 

I had the same problem. I bought a SE-R that came with no remotes. Went out on ebay and bought one for $15 with shipping. I then used this website to help. It took me three tries and about 10 minutes of my time. Very easy to do, just follow the directions exactly.

How to program a remote key Fob? - Automotive Message Forums

 

Well the keyless is programmed now for my car...

Well I took it to Nissan Service Centre here in abu dhabi and this guy programmed the remote .everythings working fine the doors the horn the trunk ... but not for free. they charged me 20 US $....
they are making me nuts ... :banghead:

By the way is there a way to bring the windows down using the remote ??

 

Well I took it to Nissan Service Centre here in abu dhabi and this guy programmed the remote .everythings working fine the doors the horn the trunk ... but not for free. they charged me 20 US $....
they are making me nuts ... :banghead:

By the way is there a way to bring the windows down using the remote ??

hold the unlock button...and yea they dont roll up if you hold the lock button

 

If you need to just order the instructions please check our website at

Programming instructions : Keyless Entry Remotes, Car Remotes, Truck Remotes,

If you have any more questions or have any specific inquiries about programming your vehicle please contact us at customercare@carandtruckremotes.com including year, make and model of your vehicle.

You can also view our FAQ page for answers to common questions. Link below
FAQ's : Keyless Entry Remotes, Car Remotes, Truck Remotes,


Best Regards

Customer Care
Home of Car and Truck Keyless Entry Remotes, Keyless Car Remotes Discount Remotes for Cars Trucks Minivans
Remote Keyless Entry - NewKeylessRemotes.com
www.keylessentrystore.com Home Page

 

1. Close all doors and lock all doors

2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds.
(The hazard warning lamp will then flash.)
NOTE:
Key should be withdrawn from ignition key cylinder completely each time.

NOTE:
Do not rush the insertion/removal key cycling process. The side
marker/tail/license lamps and interior illumination will flash twice when this step is
accurately completed.

3. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position
At this time, the new ID code is entered and original (previous) ID codes are erase.

4. Press any button on the new remote controller once. (The hazard warning lamp will then flash)

NOTE:
Do not press the button more than one time in the above step. If the button
is pressed more than one time, the programming procedure will not be successful.
The side marker/tail/license lamps and interior illumination will flash twice when this
step is accurately completed and programming is successful.

If there is only one remote controller skip step 5.

5. Additional ID code entry
Release the door lock, then lock again with door lock/unlock switch
(In power window main switch)

6. Remove key from ignition

7. Unlock driver side door, open driver side door and then close the door. (END)