The Nissan Club banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I am having a hell of a time trying to loosen the axle nut to remove the rotor, I have even stood on the breaker bar with no luck. Any suggestions
Thanks in advance
Legend
 

·
dismember
Joined
·
11,347 Posts
don't need to remove the nut. thread 2 bolts in the holes on the rotor. it'll free the rotor from the hub.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
ChiaDog, Thanks!...So the rotor slides over the wheel studs, and the 4 studs are attached to the hub not the rotor?whats the nut holding on? I was curious about the jacking holes what they where there for...By chance, what size bolts? and metric or standard?

Legend
 

·
Import Tech.
Joined
·
4,670 Posts
Rotors are held on by the wheels ...and it is an 8mmx1.25 bolt .....
 
1 - 6 of 6 Posts
Top