The Nissan Club banner
1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I was changing the rear springs on my 11 Altima. Its a one bolt job, the one that runs through the lower control arm and connects to the wheel hub assembly.

Im not sure if the lower control arm got bent during the spring install or what happened, but no matter how much leverage I apply, I can't get the holes to line up to get that bolt back through. I can get it vertically lined up, but 2/3 of the bolt is too far forward, and there is nothing to pry against to move it back.

Is there another way I can get this back on?
 
1 - 2 of 2 Posts
Top