[ok]

How do i get the panel off so i can install the radio. I cant figure it out, any help pls!!!

 

[Grimmwold]

http://www.installdr.com/InstallDocs/Nissan/PDF/647013.pdf

Note: Removing the shifter trim should be done from the back(towards the center console armrest)

The 2nd gens only have 2 screws near the front of the shifter.

When I did my 2nd gen, I stopped after step 3. I didn't remove the plastic panel under the steering wheel.

 

[zedlav]

For the first gen.

1. Unscrew shifter knob.
2. Remove the shifter trim by pulling up it at the back end. It will snap out.
3. You will see screws after snapping the shifter trim out. Unsrew.
4. Take out the ashtray and unplug the lighter terminals.
5. From here you will see that the front trim where the stereo should be placed shall be loosen.
6. the cover under the steering should be loosen once you take out the front trims.

 

[jbuffethed]

FOR THE 2ND GENS. POP THE PIECE OFF AROUND THE SHIFTER. 2. 2 SCREWS IN FRONT OF SHIFTER AND 2 UNDER THE A/C. 3. POP OFF THE FRAME AND TAKE THE 4 SCREWS OUT FROM AROUND THE RADIO.