The Nissan Club banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So I've spent the last three days attempting to properly bleed my clutch. I have a '97 240sx and my clutch master cylinder went out. So I went ahead replaced the slave and master cylinder and I haven't been able to build any more than a very small amount of pressure. I pump and pump and pump the pedal, bleed, fluid comes out, but after an hour or two no more pressure builds. The pedal has built enough pressure that it comes maybe an inch or two off the floor, but nowhere near where it should be returning to. I'm at my wits' end at this point, I've searched the forums to no avail. There's gotta be something stupid I'm missing. Any help would be greatly appreciated. Thanks!
 
1 - 1 of 1 Posts
Top