The Nissan Club banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
After I installed the VIAS and EGR plates to the intake manifold, Im getting a P1273 code. Im pretty sure I applied sufficient RTV gasket maker on each plate and installed the vacuum cap. Any other reasons might throw P1273 code?

For the P0400 EGR code, I need to install a 10K ohm resistor on the EGR sensor connector?
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #2 ·
Other observations. Before I installed the plates, the car was throwing the P1273 code, but very rarely. Maybe I have a bad A/F sensor or an intake leak somewhere?

Any help is appreciated.
 
1 - 2 of 2 Posts
Top