The Nissan Club banner
1 - 3 of 3 Posts

·
Registered
Joined
·
0 Posts
Discussion Starter · #1 ·
I just got a replacement keyless entry remote for my 1999 Altima GXE. When I follow the directions provided I can only enable one remote, the other two cannot be enabled.

Does anyone have instructions for programming multiple keyless entry remotes?

Thanks!
 

·
Formerly LordofSearchMod
Joined
·
14,715 Posts
straight from my 1999 Service Manual...

1)close all doors and locks

2)Insert and remove the key from ignition cylinder more than 6 times within 10 seconds (hazard warning will then flash) at this time all original id codes are wiped

3)Turn ignition switch to ACC position

4)Flash any button on the new remote control ONCE (hazard lamps will then flash) at this time, new ID code is entered

Do you want to enter any additional codes? (Max of 4)

YES: Release the door lock, then lock again with door lock/unlock switch (in power window main switch) Then Repeat step 4

NO: Unlock driver side door and open driver side door (END) Check operation of remotes
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top