The Nissan Club banner

1 - 12 of 12 Posts

·
your mexican connection
Joined
·
457 Posts
Crajy:
I have been in manufacturing quite sometime and have a little experience in injection molding. Over all both fiberglass and ABS will be fine. My personal preference is fiberglass, I thinks it is more resistant.
 

·
Registered
Joined
·
1,656 Posts
i would think an OEM would use urathane, but i guess that will drive up cost alot
 

·
A+, MCP
Joined
·
1,111 Posts
ABS Plastic, DesiEGO. I started a thread like this before and I bought both and kept the ABS Pastic. Fiberglass will never give you perfect surface.
 
1 - 12 of 12 Posts
Top